CAN232

General Information:

CAN232 is a very small dongle that plugs into any PC COM Port, or any other RS232 port in an embedded system and gives an instant CAN connectivity. This means it can be treated by software as a standard COM Port (serial RS232 port) which eliminates the need for any extra drivers. Sending and receiving can be done in standard ASCII format.

Dimensions:

Length: 68mm, Width: 31mm, Height: 16mm.

Features:

The module plugs directly into a standard serial port and provides a standard DB9 male output to CAN systems according to CiA (CAN in Automation) recommendations. It is powered with 8-15VDC through the CAN connector with ESD protection and reveresed power. It consumes max 100mA, but normally not more than 40mA (this depends on BUS load and eventual CAN cable errors etc.). Use your own RS232 LIB/drivers (in e.g. Visual Basic, Deplhi, C++ etc.).

Pin assignement:

Pin assignement according to CiA recommendations DS102-1.
The CAN232 is powered with +Vin (9-15VDC) at pin 9 and GND at pin 3.

How to connect:

The picture above shows how to connect the CAN232.

CAN232 Manual:

CAN232 Manual

Sample Programs and drivers:

Sample programs in C, C++, Visual Basic, Delphi, Linux etc. can be found on the download page.

CANUSB

Preliminary Information!

CANUSB will be availible June 1st 2005, more information at www.canusb.com. We will display the CANUSB at the Embedded World in Nürnberg 2005 from the 22nd to the 24th in the Elektronikladen Booth 12/503. Basically CANUSB has same commands as CAN232, though some removed (such as Poll One and Poll All) since it is a new product and we do not need to be backward compatible. With CANUSB you will get increased bandwith of CAN and can work at higher busloads. Our goal is to make it the choice of CAN to USB converters if you work with CAN speeds up to 250Kbit/100% busload, 500Kbit 50% busload or 1Mbit 25% busload. We feel the market need a low cost CANUSB device with same functionallity and easyness as the CAN232. Price is target to be arround 129 EURO in single quantity. CANUSB will work on both Windows and Linux platforms.

Looking inside the CANUSB, you find a dense 4-layer printed circuit boards with parts on both sides of the PCB. The CANUSB will be firmware upgradable through the USB interface, so customers easily can update firware when we release a new improved software or new functions in the software. CANUSB is also CE ceritified, which many other similar products are not.

Read more at www.canusb.com